Распиновка коннектора приборной панели ауди 100 45 кузов.

Вырезка из мануала на английском языке. Взято с форума Ауди-клуба Воронеж.

Contacts on 26-pin, red multi-pin dash panel insert connector

‒ Consult appropriate current flow diagram.
1 — Positive for indicator lamp no. 13 (main beam)
2 — Negative for indicator lamp no. 12 (diesel/CAT)
3 — Negative for fuel gauge
4 — Negative for warning lamp no. 11 (handbrake)
5 — Negative for warning lamp no. 10 (ETC)
6 — Not used
7 — Vehicle speed signal (output)
8 — Vehicle speed signal (input from travel sensor)
— Checking => Page 90-65
9 — Not used
10 — Terminal 31
11 — Terminal 15 (positive for electronic speedometer and voltage stabiliser)
12 — Plus for indicator lamp no. 2 (right turn-signal indicator)
13 — Negative for warning lamp no.9 (ABS)
14 — Terminal 30
15 — Not used
16 — Not used
17 — Input, terminal 58 (positive from light switch to instrument lighting brightness control)
18 — Output, terminal 58
19 — Not used
20 — Not used
21 — Not used
22 — Output terminal 58d
23 — Not used
24 — Not used
25 — Positive for indicator lamp no.3 (left turn-signal indicator)
26 — Not used

Contacts on 26-pin, green multipin connector on dash panel insert

‒ Consult appropriate current flow diagram.
1 — Negative from warning contact for bRake fluid level
2 — Negative for engine electronics malfunction (only with mini-check system)
3 — Negative for coolant temperature too high
— Checking => Page 90-69
4 — Not used
5 — Negative from 0.3 bar oil pressure switch
— Checking => Page 90-62
6 — Negative from bRake linings
7 — Terminal 15
8 — Not used
9 — Not used
10 — Negative for warning lamp no.14 (charge warning)
11 — Terminal 31
12 — Input from engine control unit for rev counter (rev counter signal)
13 — Not used
14 — Negative from 0.9/1.8 bar oil pressure switch
— 4-/5-cylinder engine: 1.8 bar oil pressure switch
— 6-cylinder engine: 0.9 bar oil pressure switch
15 — Vehicle speed signal (output)
16 — Negative for coolant temperature gauge
17 — Negative for indicator lamp no.12 (Diesel/CAT)
18 — Not used
19 — Not used
20 — Not used
21 — Not used
22 — Not used
23 — Not used
24 — Terminal 31 (coding for 5 cylinders)
25 — Not used
26 — Not used

Contacts at 4-pin connector on dash panel insert (side section) with additional instruments
1 — Oil pressure gauge signal
2 — Oil temperature gauge signal
3 — Not used
4 — Not used

Contacts at 6-pin connector on dash panel insert (side section) with additional instruments
1 — Analogue clock adjustment
2 — Terminal 30
3 — Terminal 15
4 — Terminal 58
5 — Terminal 58d
6 — Terminal 31